Avago Technologies LSI20160 - Manual (Page 184)

8-4 SCO OpenServer 5 Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
•
LSI53C1000 (LSI20160, LSI20160L)
•
LSI53C1010 (LSI21003, LSI21040, LSI22915A, LSI22903,
ITI6200U3LP)
8.1.3 Description
UNIX installation on a SCSI system requires creation of a SCO
OpenServer 5 kernel that contains the SCSI driver to support SCSI
devices. The two possible installation procedures are:
•
Installing UNIX and the proper SDMS BTLD driver for the first time
on a SCSI boot drive.
•
Loading or updating the proper SDMS BTLD driver on a boot drive.
Read the important information below before beginning any installation
procedure.
•
This driver supports all releases of SCO OpenServer 5
(Releases 5.0.2, 5.0.4, and 5.05).
•
The diskette contains package slha , which is used for all SCO
OpenServer 5 Releases.
•
Within the text instructions for adding SCSI Disk Drives, Tape Drives,
and CD-ROM drives, the system prompts you to check whether the
driver is the default value or to enter the exact driver name. The
package name and the driver name are
slha .
8.2 Building an SDMS 4.0 BTLD PCI Diskette
The SDMS Software Device Drivers and Utilities CD-ROM contains the
sco.
dd image file for SCO OpenServer operating systems in this
directory:
{UNIX CDROM path}/drivers/unixes/opnservr
To create a BTLD driver diskette to use with SCO OpenServer
installations, copy the raw
dd image file onto a 1.44 Mbyte diskette. Refer
to the instructions below for UNIX System and DOS System Users.