Avago Technologies LSI20160 - Manual (Page 168)

7-8 OS/2 Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
•
Update drivers for existing LSI Logic host adapters
To add or update SDMS OS/2 drivers, follow these steps:
Step 1. Open the System Setup folder located within the OS/2 System
folder at the OS/2 Desktop.
Step 2. Open the Install/Remove folder and then double click on the
Device Driver Install icon.
Step 3. Insert the diskette containing the SDMS device driver(s) in the
source drive.
The system will find all DDP files on the diskette and
automatically install the corresponding drivers.
Verify that the installation was successful by following steps 4
through 7.
Step 4. Open the Utilities folder located within the Programs folder on
the OS/2 Desktop.
Step 5. Double click on the OS/2 System Editor to start the editor.
Step 6. Open the CONFIG.SYS file in the root directory and find the
line(s):
BASEDEV=SYM8XX.ADD /V
and/or
BASEDEV=SYM_HI.ADD /V
If installing both drivers, make sure that the BASEDEV= lines for
the drivers appear in the CONFIG.SYS file in the order in which
the drivers must load. Refer to the Section 7.3.2.1, “Driver
Order in the CONFIG.SYS File,” in this document to understand
the importance of driver order.
Step 7. Check the appropriate drivers are in the \OS2\BOOT directory on
the boot drive.
7.3.2.1 Driver Order in the CONFIG.SYS File
Because of the way OS/2 assigns drive letters, the order in which drivers
appear in the
CONFIG.SYS file is important. The drivers must appear in
the order in which the drive letters are to be assigned. In particular: