Avago Technologies LSI20160 - Manual (Page 250)

12-16 NetWare Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
12.5 Important Additional Information
This section provides information regarding specific driver options and
various DOS dependencies.
12.5.1 Specific Driver Options
This document addresses options available on the SDMS NWPA HAM
drivers, versions 4.02.00 or later. For information pertaining to a specific
driver, please do one of the following:
•
For NetWare version 4.XX, consult the *.DDI file for options available
for LSI8XXNW.HAM , LSIHINW.HAM , and/or LSI_U3NW.HAM drivers.
Refer to the NetWare installation utility to access these files.
•
Load the driver specifying the ? option on the command line of the
LSI8XXNW.HAM , LSIHINW.HAM , and/or LSI_U3NW.HAM drivers. The
system displays the available options for the driver without loading
the driver.
12.5.2 DOS Access Dependencies
Typically, NetWare requires access to the DOS partition (perhaps to load
a file or to shutdown the system). The
LSI8XXNW.HAM , LSIHINW.HAM ,
and/or LSI_U3NW.HAM drivers support several SDMS DOS
configurations.
The HAM drivers detect whether an older SDMS 4.XX BIOS exists on
the system and if the
ASPI8XX.SYS DOS driver is loaded. If you are using
the unsupported SDMS 3.XX BIOS or using an older supported SDMS
4.XX, then
ASPI8XX.SYS (version 4.10 or greater) must also be loaded.
Note: LSI8XXNW.HAM , LSIHINW.HAM , and LSI_U3NW.HAM do not
support the SDMS 3.XX DOS drivers: DOSCAM and MINICAM .
12.5.3 Supported DOS Configurations
The HAM drivers support these DOS configurations:
•
SDMS 4.18 or greater BIOS (No DOS Drivers required)
•
SDMS 4.XX BIOS, ASPI8XX.SYS (version 4.10 or greater)
•
No SDMS BIOS, ASPI8XX.SYS