Avago Technologies LSI20160 - Manual (Page 153)

Additional DOS Utilities 6-27
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
6.6.2.2 Description
This utility provides a user-friendly way to configure any of the
DOS-based drivers for the
CONFIG.SYS file. It assumes the LSI Logic
SCSI drivers are already installed. The SDMS ASPI driver, ASPI8XX.SYS ,
must be present and loaded for this utility to run. Online help is available
at each step for each screen you encounter. You may press F1 at any
time for a list of all the help available.
6.6.2.3 Running the DOS Configuration Utility
To run this utility, several files are required:
•
CONFIG.EXE
•
CONFIG.DAT
•
8BITBUS.PCX
•
16BITBUS.PCX
•
ADAPTERS.PCX
•
LUNVIEW.PCX
•
TILE.PCX
•
VIEWIT.PCX
•
ASPI8XX.SYS
If ASPI8XX.SYS already exists on the system and the driver line points to
it in the CONFIG.SYS file, you do not need it in the same directory as
CONFIG.EXE . It is included here in case the installation of the drivers has
not yet taken place. If this is the case, add the following line to the
CONFIG.SYS file:
DEVICE=[path]ASPI8XX.SYS
Then, reboot for it to take effect. The path specified in the above line is
your choice (
C:\LSILogic is recommended), and ASPI8XX.SYS must be
copied to that location.
If you wish to configure the SYMDISK.SYS or SYMCD.SYS DOS drivers,
they also require installation prior to running the SCSI BIOS
Configuration Utility. To do a full installation of all the DOS drivers, run
the DOS Installation Utility.