Avago Technologies LSI20160 - Manual (Page 120)

5-16 Windows 2000 Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
When the installation has completed, you can move the files from the
Windows NT (WINNT) folders to appropriate folders within the Windows
2000 (WIN2K) folder.
During installation, no SCSI devices are found.
•
Ensure that the custom setup is chosen on the Setup Method
screen.
•
Ensure that all devices are powered on and terminated correctly.
•
Check that no devices have duplicate SCSI IDs.
•
Make sure INTA is assigned for the PCI slot(s) where your SCSI host
adapter(s) are installed.
•
Ensure that all devices can be seen in the display banner of the
SDMS SCSI BIOS at boot time.
•
For systems with some versions of the Award BIOS, ensure that the
PCI IRQ is set to edge triggered.
System crashes during installation with a message indicating
inaccessible boot device.
•
This error is usually associated with an IRQ, DMA channel, I/O (chip)
address, or BIOS address conflict. Set the SCSI host adapter to use
a different interrupt.
•
A virus sometimes causes this error that infects the Master Boot
Record of the boot device. Use a write protected DOS bootable flex
containing virus scanning and cleaning software to check for any
viruses on the boot device, and remove if any are found.
A disk drive is recognized as seven different devices when only one
is physically connected to the SCSI bus.
Older SCSI devices that incorrectly indicate that they support multiple
LUNs to Windows 2000 usually cause this error.
•
Contact the device manufacturer for a firmware upgrade.
•
Ensure that there are no devices with the same SCSI ID as the host
adapter board.