Avago Technologies LSI20160 User Manual
Page 190
8-10
SCO OpenServer 5 Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
Press Enter.
8.3.2.1 Adding a SCSI Disk Drive
If you are not adding a SCSI disk drive to this system, go to
Section 8.3.2.2, “Adding a SCSI Tape Drive.”
Step 1.
To add a SCSI disk drive, type at the command prompt:
mkdev hd
Press Enter.
The system prompts for the identifier of the host adapter that
supports this device.
Step 2.
Press Enter if the default is correct. If it is incorrect, type:
slha
Press Enter.
The system prompts for the host adapter that supports the disk
drive.
Step 3.
Type the correct host adapter number and press Enter.
If an additional LSI Logic host adapter is being added to the
SCO OpenServer kernel, the system may prompt if you want to
update the link-kit (add another host adapter).
Type
y
and press Enter if you entered the host adapter number
correctly:
or
Type
n
and press Enter if you entered the host adapter number
incorrectly. The system then prompts for the host adapter
identifier of the preceding step.
The system prompts for the SCSI bus number of the disk drive.
LSI Logic host adapters support one bus per adapter.
Step 4.
Press Enter to get the default bus number of zero or type zero
(0) and press Enter. Note that dual channel devices appear as
two host adapters.
The system prompts for the Target ID of the disk drive.
Step 5.
Type the SCSI ID number of the disk drive and press Enter.