Avago Technologies LSI20160 User Manual
Page 52
3-6
Windows 95, Windows 98, Windows Me Device Driver Installation
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
installed during Windows Setup. To change to the
SYMC8XX.MPD
,
SYM_HI.MPD
, or
SYM_U3.MPD
drivers, follow
the instructions in
Section 3.3.2, “Existing System
after the Windows 95/98/Me installation has
completed.
Follow these instructions for new system installations:
Step 1.
Start the Windows 95, Windows 98, or Windows Me Setup
according to the Microsoft instructions.
Step 2.
Setup enters the hardware detection phase after a system
reboot.
If the message Symbios™ PCI SCSI Host Adapter appears,
then the bundled driver supports the host adapter, and it installs
automatically. After the Windows installation has completed,
you can install the
SYMC8XX.MPD
,
SYM_HI.MPD
, and/or
SYM_U3.MPD
drivers according to the instructions for an
existing system installation
Step 3.
If the bundled driver does not support the host adapter, Setup
displays a New Hardware Found - PCI SCSI Bus Controller
dialog box.
Step 4.
Select
Driver from disk provided by hardware
manufacturer
and click OK.
Note:
If
ASPI8XX.SYS
(the SDMS 4.0 DOS ASPI driver) is loaded
when beginning the Windows 95/98/Me installation, no
messages about PCI SCSI Bus Controllers will appear. The
installation completes, but real-mode disk drivers are used.
Refer to
Section 3.3.4, “Verifying Correct Driver
for more information.
To install the
SYMC8XX.MPD
,
SYM_HI.MPD
, or
SYM_U3.MPD
,
drivers, (which disable loading of the
ASPI8XX.SYS
driver
under Windows 95/98/Me) refer to
System Using ASPI8XX.SYS DOS ASPI Driver,” page 3-10
for installation instructions.
Step 5.
Insert the SDMS driver diskette into drive
A:
(or
B:
) If using
drive
B:
, you must select it from the pick list.
Windows 95/98/Me automatically copies the appropriate driver
files and rebuilds its driver database.