Avago Technologies LSI20160 - Manual (Page 143)

About the SYMDISK.SYS Driver 6-17
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
1. Is the SCSI BIOS seen during boot?
2. Does the SCSI BIOS see the bootable SCSI drive?
When the computer boots, SDMS scans the SCSI bus. Devices
found on the SCSI bus are identified as in the following lines:
3. If booting is still unsuccessful, follow the solution to the next problem.
YES Go to 2.
NO Power down all units in the system.
Remove all SCSI cables.
Boot system.
Is the SCSI BIOS seen during boot?
YES Power down all units in the systems.
Reconnect and check all cable and power connections.
Boot system.
NO Power down all units in the system.
Reset the host bus adapter.
Check CMOS setup.
Boot system.
Go to 1.
HA ID LUN VENDOR PRODUCT REV
0 2 0 SEAGATE ST31230N 0060
0 7 0 LSI Logic LSI53C815 0003
YES Go to 3.
NO Power down all units in the system.
Make sure the hard drives have different ID numbers (boot drive
should have the lowest ID).
Make sure both ends of the SCSI bus are terminated.
Check all cable and power connections.
Check CMOS setup.
Boot system.
Go to 1.