Avago Technologies LSI20160 - Manual (Page 8)

viii Contents
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
3.3 Installing Drivers for Windows 95/98/Me 3-5
3.3.1 New System Installation 3-5
3.3.2 Existing System Installation 3-7
3.3.3 Existing System Using ASPI8XX.SYS DOS
ASPI Driver
3-10
3.3.4 Verifying Correct Driver Installation 3-11
3.4 Troubleshooting 3-13
3.5 Using the Command Line Options 3-14
3.5.1 Enabling/Disabling Ultra SCSI Support 3-15
3.5.2 Disabling Auto Request Sense Support 3-15
3.5.3 Enabling SCAM Support 3-16
3.5.4 Disabling Domain Validation Support 3-17
3.5.5 Multiple LSI Logic Host Adapters Considerations 3-19
3.6 Using SCSI Tools for Windows 95/98 3-20
3.6.1 Features 3-20
3.6.2 Installing SCSI Tools for Windows 95/98 3-21
Chapter 4 Windows NT 4.0 Device Driver Installation
4.1 Introduction 4-1
4.1.1 Features 4-4
4.1.2 LSI Logic Devices Supported 4-4
4.1.3 Description 4-5
4.2 Using the SDMS Windows NT Drivers 4-7
4.2.1 Preparing an SDMS Driver Diskette 4-7
4.3 Installing Drivers for Windows NT 4-7
4.3.1 New System Installation 4-7
4.3.2 Existing System Installation 4-11
4.4 Performance Tuning for Windows NT 4.0 4-13
4.4.1 Supporting Large Block Size 4-13
4.4.2 Maximum Number of Concurrent I/Os
(Guaranteed)
4-14
4.4.3 Disk Mirroring 4-15
4.5 Troubleshooting 4-17
4.6 Using the NT Configuration Utility 4-20
4.6.1 Installing the NT Configuration Utility
(x86 Platforms)
4-21
4.6.2 Starting the NT Configuration Utility 4-21
4.6.3 Exiting the NT Configuration Utility 4-31