Avago Technologies LSI20160 User Manual
Page 167
Installing Drivers for OS/2
7-7
Copyright © 1993–2001 by LSI Logic Corporation. All rights reserved.
In order to do so, you must delete files on Diskette 1 to provide
space. Consult the
README.1ST
file on the Device Driver Pak. It
contains a list of files that may not be deleted. Follow the
instructions provided in the
README.1ST
file. Once space is
made available on Diskette 1, copy the appropriate SDMS
device driver onto this diskette.
When
ADD
drivers are deleted from Diskette 1, make certain to
delete or remark out the corresponding
BASEDEV=
statement in
the
CONFIG.SYS
file. Otherwise, error messages will show up
during installation.
Step 4.
Edit the
CONFIG.SYS
file on the copy of Diskette 1 by adding
one of the following lines at the end of the file:
BASEDEV=SYM8XX.ADD /V
or
BASEDEV=SYM_HI.ADD /V
If installing both drivers, make sure that the BASEDEV= lines
for the drivers appear in the
CONFIG.SYS
file in the order in
which the drivers must load. Refer to
to understand the
importance of driver order.
Step 5.
Follow the directions in the
README.1ST
file for adding the
following line to the
CONFIG.SYS
file:
SET COPYFROMFLOPPY=1
This allows the SDMS driver to be copied from the installation
diskette to the system's boot drive.
Step 6.
Place the copy of Installation Diskette in the
A:
drive and reboot
the computer.
Step 7.
Proceed with the OS/2 installation process as documented in
the OS/2 Installation Guide.
7.3.2 Updating SYM8XX.ADD/SYM_HI.ADD for Existing System
Installations
This section provides instructions for existing system installations. Apply
these instructions when you have to:
•
Add drivers for newly installed LSI Logic host adapters, or