Comtech EF Data CDM-625 - Manual (Page 565)

CDM-625 Advanced Satellite Modem Revision 15
Appendix E MN-CDM625
E–37
Hot
Key Dialog Window
Option Entry
B Statistics Sample Interval Use the ↑↓ arrow keys to select Disabled, or 10 minutes to 90 minutes
C Request To Send
Use the ↑↓ arrow keys to select Loop No Action, Loop RTS Controls
Tx Output, or Ignore RTS Assert CTS
D HSSI Handshake Control
Use the ↑↓ arrow keys to select TA To CA Loop or RR Control CA TA
Control TxS
E Circuit ID Enter a Circuit ID value as needed
F Carrier ID Use the ↑↓ arrow keys to select Disable or Enable
G RTC Time Enter a value in the form HH:MM:SS
H RTC Date Enter a value in the form DD:MM:YY
I Tx Clock Source
Use the ↑↓ arrow keys to select Internal, Tx Terrestrial, Rx Loop
Timed, or Rx Sat
J Rx Clock Source
Use the ↑↓ arrow keys to select Rx Satellite, Tx Terrestrial, Internal
SCT, or Insert
K Rx Buffer Size Enter a value from 16 to 32768
L Modem Reference Clock
Use the ↑↓ arrow keys to select:
• Internal • External 1 MHz • External 2 MHz
• External 5 MHz • External 10 MHz • Internal Plus Output
M G703 Clock Extend Mode Use the ↑↓ arrow keys to select None, Tx Lock, or Rx Enable
N G703 Clock Extend Intf Use the ↑↓ arrow keys to select T1, E1 Balanced, or E1 Unbalanced
O Warm Up Delay Use the ↑↓ arrow keys to select Disable or Enable
P Warm Up Countdown Enter a value from 0 to 999 seconds
Q BERT Restart Monitor Use the ↑↓ arrow keys to select No or Yes
R BERT Tx State Use the ↑↓ arrow keys to select Off or On
S BERT Tx Pattern
Typical for either entry – Use the ↑↓ arrow keys to select:
• BERT Pattern Space • BERT Pattern Mark • BERT Pattern 11
• BERT Pattern 12 • BERT Pattern 63 • BERT Pattern 511
U BERT Rx Pattern
• BERT Pattern 2047 • BERT Pattern 2047 R • BERT Pattern MIL188
• BERT Pattern 2^15 • BERT Pattern 2^20 • BERT Pattern 2^23
T BERT Rx State
Typical for each entry – Use the ↑↓ arrow keys to select Off or On V BERT 10^-3 Error Insert
W Recenter Buffer
Press a hot key to open a dialog window. Otherwise, press [ESC] to return to the Modem
submenu.