Comtech EF Data CRS-150 User Manual
Crs-150
IMPORTANT NOTE: The information contained in this document supersedes all previously published
information regarding this product. Product specifications are subject to change without prior notice.
Part Number MN/CRS150.IOM
Revision 2
CRS-150
1:1 Redundancy Switch
Installation and Operation Manual
Accessory Product for use only with
Comtech EF Data CDM-600 Modems
(Requires Modem Firmware Version 1.1.0 or Higher)
Table of contents
Document Outline
- mn-crs150_r2.pdf
- INSIDE COVER
- TABLE OF CONTENTS
- TABLES
- FIGURES
- PREFACE
- Chapter 1. INTRODUCTION
- Chapter 2. INSTALLATION
- Chapter 3. CONNECTOR PINOUTS
- 3.1 Connector Overview
- 3.2 Front Panel Connectors
- 3.3 Rear Panel Connectors
- 3.4 Data Interface Converter Modules / Adapters
- Chapter 4. CABLES AND CONNECTIONS
- 4.1 Overview
- 4.2 Cabling to the CDM-600
- 4.3 Cabling to the CDM-600L (CLM-9600L)
- Chapter 5. MODEM AND SWITCH CONFIGURATION
- Appendix A. CABLE DRAWINGS
- A.1 Introduction
- A.2 Control Interface Cables
- A.3 IF / Utility / Data Interface Cables
- A.3.1 Modem-to-Switch/User IF (70/140 MHz) Coax Cable, Type ‘BNC’ 50Ω
- A.3.2 Modem-to-Switch Data Cable, DB-15M ( DB-15M
- A.3.3 Modem-to-Switch Coax Cable, Type ‘BNC’ 75Ω
- A.3.4 Modem-to-Switch Universal Control/Data Cable, DB-25M ( DB-25M
- A.3.5 Modem-to-Switch Universal Control/Data Cable, DB-15M ( DB-15M
- A.3.6 Modem-to-Switch Data Cable, DB-25M ( DB-25M
- A.3.7 Modem-to-Switch Data Cable, DB-9M ( DB-9M
- METRIC CONVERSIONS
- BACK COVER