Comtech EF Data CDM-625 - Manual (Page 200)

CDM-625 Advanced Satellite Modem Revision 15
Ethernet-based Remote Product Management MN-CDM625
6–8
6.5 Web Server (HTTP) Interface
A user-supplied Web browser allows the full monitor and control (M&C) of the CDM-625 from
its Web Server Interface. The CDM-625’s embedded web application is designed for, and works
best with, Microsoft’s Internet Explorer Version 9.0 or higher. Comtech EF Data does not
recommend setting your browser to IE7 Compatibility Mode.
6.5.1 User Login
Type the CDM-625’s IP Address (shown here as http://xxx.xxx.xxx.xxx) into the Address area of
the User PC Web browser:
The Login window will appear, similar to the
example shown here, opens. Enter the
assigned User name and Password. The Web
Server Interface default user names and
passwords are as follows:
• Admin: comtech/comtech
• Read/Write: opcenter/1234
• Read Only: monitor/1234
HTTP Login User Access Levels are further defined as follows:
HTTP Login User Access Level
Admin User Read/Write User Read Only User
Full Access to all
web pages.
No Access to Admin or IP Packet Processor-
related web pages.
No Access to Admin or IP Packet Processor-
related web pages.
Full Access for all other web pages View Only Access for all other web pages.
Type the User Name and Password, and then
click [OK].
Once the valid User Name and Password is
accepted, you will see the CDM-625 Web
Server Interface “splash” page, as per the
following example (note that the Base Modem
and optional IP Packet Processor Firmware
Versions listed here are subject to change):
To properly access the CDM-625 Web Server Interface, you must first configure remote control
access for the unit to Ethernet mode. If you attempt to log in to the Web Server Interface and