Comtech EF Data CDM-625 - Manual (Page 425)

CDM-625 Advanced Satellite Modem Revision 15
IP Packet Processor Option MN-CDM625
18–13
Step Task
6 Prepare the IP Packet Processor Card for installation by
aligning its receptacle with the mating connector on the
modem’s framing board.
Plug the card firmly into the connector – take care not to
damage any top-mounted components. Similarly, be sure
not to damage the bottom of the card on the chassis’
mounting bosses while plugging the card receptacle into its
mating connector.
Installation is complete once the cable connector is fully
engaged within its mating receptacle, and the mounting
holes at the front of the card are aligned with the mounting
boss threaded holes.
7 Use the screwdriver to secure the IP Packet Processor card
to the chassis with its provided mounting hardware (2X 4-
40 x 1/4 pan head screws).