Comtech EF Data CDM-625 - Manual (Page 184)

CDM-625 Advanced Satellite Modem Revision 15
Front Panel Operation MN-CDM625
5–84
5.2.6.7 Utilities: Firmware
THESE MENUS ARE FOR DIAGNOSTIC PURPOSES. ONLY CHANGE AN IMAGE IF
INSTRUCTED TO DO SO BY A COMTECH EF DATA CUSTOMER SUPPORT
TECHNICIAN.
Firmware Images:
Base-Modem Packet-Processor ()
Use the ◄ ► arrow keys to select Base-Modem or Packet-Processor, and then press ENTER.
5.2.6.7.1 Utilities: Firmware  Base-Modem
Firmware Information:
Boot-ROM Image#1* Image#2 Select ()
Use these submenus to view information about the CDM-625 Base Modem internal firmware.
This screen identifies the firmware image that is loaded on startup or reboot of the Base Modem
with an asterisk (*). Use the ◄ ► arrow keys to select Boot-Rom, Image#1, Image#2, or Select,
and then press ENTER.
5.2.6.7.1.1 Utilities: Firmware  Base-Modem  Boot-ROM, Image#X
Bootrom: DD/MM/YY
FW/12865X #.#.#
The example shown here is for the Bootrom firmware opening screen. Typical for the Image#1
or Image#2 screens, you may use the ▲▼ arrow keys to scroll through information for all the
constituent firmware blocks that make up the bulk.
This read-only information is provided for: firmware type; its number (where ‘X’ is the revision
letter); its build date (in day/month/year format); and its version number (e.g., 2.1.0). Press
ENTER or CLEAR to return to the previous menu.
5.2.6.7.1.2 Utilities: Firmware  Base-Modem Select
Current Active Image is #1
Next Reboot, will use Image: #1 ()
The modem can store two complete firmware images. Use this menu to select which image is
loaded the next time the unit reboots. The top line shows the current active image while, on the
bottom line, you may use the ▲▼ arrow keys to select the other image. Press ENTER when