Comtech EF Data CDM-625 - Manual (Page 471)

CDM-625 Advanced Satellite Modem Revision 15
Appendix D MN-CDM625
D–7
D.5 Remote Commands and Queries
D.5.1 Table Indexes
Notes:
1. Index Columns – Where Column ‘C’ = Command, and Column ‘Q’ = Query, columns marked ‘X’ designate the instruction code as
Command only, Query only, or Command or Query. Where CODE = XXX, this indicates a priority command.
2.
= Message ok
In the tables that follow, the following codes are used in the ‘Response to Command’ column (per Sect. D.5.5):
# Message ok, but unit is not in Remote mode.
? Received ok, but invalid arguments were found. ~ Time out of a pass-through message, either to via EDMAC or to a local ODU
^ Message ok, but unit is in Ethernet mode.
Sect. D.5.2 Tx Parameters
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE
APP X X D-16 TBA X X D-17 TFQ X X D-13 TMX X X D-13 TTF X D-18
AUP X X D-15 TCI X X D-17 TFT X X D-11 TPL X X D-14 TVL X X D-17
DTS X X D-17 TCK X X D-16 TIR X D-18 TRS X X D-14 TXA X X D-15
DTY X X D-17 TCR X X D-12 TIT X X D-10 TSC X X D-14 TXO X X D-15
TDI X X D-14 TLO X X D-18 TSI X X D-14
PLI X D-16 TDR X X D-13 TMD X X D-11 TSR X X D-13
TET X X D-18 TMI X D-18 TTA X X D-17
REB X D-16 TFM X X D-10 TMR X X D-13 TTC X X D-17
Sect. D.5.3 Rx Parameters
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE
EBA X X D-24 RCI X X D-24 RFM X X D-19 RMR X X D-22 RTC X X D-25
ITS X X D-25 RCK X X D-24 RFQ X X D-22 RMX X X D-22 RTE X X D-24
ITY X X D-24 RCR X X D-21 RFT X X D-20 RRS X X D-23 RTF X D-25
RDI X X5 D-23 RIR X D-26 RSI X X D-23 RVL X X D-24
RDR X X D-22 RIT X X D-19 RSL X D-46
RBA X X D-25 RDS X X D-23 RLO X X D-25 RSN X D-52
RBS X X D-24 REE X X D-26 RMD X X D-20 RSR X X D-22
RCB X D-25 RET X X D-25 RMI X D-26 RSW X X D-23