Comtech EF Data CDM-625 - Manual (Page 227)

CDM-625 Advanced Satellite Modem Revision 15
Ethernet-based Remote Product Management MN-CDM625
6–35
6.5.4.3.3.3 Configuration | Routing | DHCP
Use this page to set up the DHCP (Dynamic Host Configuration Protocol) Relay feature.
DHCP allows a device to be configured automatically – eliminating the need for intervention by a
network administrator – and provides a server located at the hub for keeping track of devices
that are connected to the network. This prevents two devices from accidentally being
configured with the same IP Address.
The CDM-625 DHCP Relay feature allows you to deploy a single DHCP server at the hub that
manages all of the devices throughout your remote networks. When a device on the CDM-625's
network issues a DHCP request, it is relayed to the DHCP server as specified by the "DHCP Server
IP Address". The DHCP response is then sent directly to the requesting device.
Figure 6-18. Configuration | Routing | DHCP page
DHCP Relay
• Relay Feature – Use the drop-down list to Disable or Enable the DHCP Relay Feature.
• DHCP Server IP Address – Specify the IP Address to be used for the DHCP server at the hub
in the form XXX.XXX.XXX.XXX.
Click [Submit] to save these settings.