beautypg.com

Chapter 18. ip packet processor option, 1 overview, 1 ip packet processor – operational requirements – Comtech EF Data CDM-625 User Manual

Page 413

background image

18–1

Chapter 18. IP PACKET

PROCESSOR OPTION

18.1

Overview

The IP Packet Processor is an optional feature for the CDM-625 Advanced Satellite Modem. In

addition to providing Layer 3 functionality, it incorporates a number of key features for Wide

Area Network (WAN) bandwidth optimization, including very low overhead Streamline

Encapsulation (SLE), Header Compression, Payload compression, Advanced Quality of Service

(QoS), and Advanced Encryption Standard (AES) Encryption.

The IP Packet Processor enables efficient IP networking and transport over satellite, in either

Router Mode or Managed Switch Mode, by adding routing capability with very low overhead

encapsulation, header compression, payload compression, and Quality of Service (QoS). The

Advanced QoS combined with header and payload compression ensures the highest quality of

service with minimal jitter and latency for real-time traffic, priority treatment of mission critical

applications and maximum bandwidth efficiency.

18.1.1 IP Packet Processor – Operational Requirements

The IP Packet Processor is available as a factory-installed option or, depending on

its originally shipped configuration, as a field-upgradeable option. Use of the IP

Packet Processor with the CDM-625 Advanced Satellite Modem requires the

following:

CDM-625 Power Requirements for the IP Packet Processor Board (CEFD P/N

PL-0000481): When ordering the IP Packet Processor as a factory installed option,

the modem power supply that is specified at the time of order must either be 175

watts for AC units, or 125 watts for DC units.

Existing field units that meet either power supply configuration requirement are

user-upgradable in the field using CEFD Kit KT-0000176 – refer to Section 18.5 in

this chapter for the field upgrade procedure using this kit.

However, existing field units that do not meet these power supply configuration

requirements – i.e., units that are configured with 65W AC or 65W DC power

supplies – must be returned either to Comtech EF Data or sent to a Comtech EF