Comtech EF Data CDM-625 - Manual (Page 212)

CDM-625 Advanced Satellite Modem Revision 15
Ethernet-based Remote Product Management MN-CDM625
6–20
Currently Running (read-only)
The current running image is identified here.
Next Reboot, will use
Use the drop-down list to select Image 1 or Image 2 as the image to use upon next reboot, and
then click [Submit] to save this selection.
6.5.4.2.3.2 Admin | Firmware | Packet Processor
This nested page is accessible only to Administators when the optional IP Packet
Processor card is installed and enabled. See Sect. 6.5.3.1 for complete details
about using conditional access pages.
Use this page to view the status window for the optional IP Packet Processor’s currently loaded
firmware, and to set the firmware load preference for the IP Packet Processor upon power-
up/reboot of the unit.
Figure 6-9. Admin | Firmware | Packet Processor page
Firmware
• (Read-only) The IP Packet Processor’s Bootrom, Image 1, Image 2, and current Running
image are identified here.
• Boot From – Use the drop-down list to boot the IP Packet Processor from Latest, Image 1, or
Image 2, and then click [Submit] to save this selection.