Comtech EF Data CDM-625 - Manual (Page 179)

CDM-625 Advanced Satellite Modem Revision 15
Front Panel Operation MN-CDM625
5–79
5.2.4.9 Info: Insert
Insert Type= CH:1
E1-CCS TS:01
An example of an Insert Info screen is shown here. This screen shows the Insert Type and
channel allocations. Press ENTER or CLEAR to return to the previous menu.
When in QDI (Quad Drop & Insert) Mode, this screen displays the same
information as the CONFIG: D&I  Drop menu.
5.2.4.10 Info: Remote
Remote-Control= Local Address= 0000
Interface= RS-232 9600 baud 8N1
An example of a Remote Info screen is shown here. This screen shows if the unit is in Local,
Remote or Ethernet (IP) mode. It also displays the electrical interface type selected, the unit’s
address, and the active baud rate.
5.2.4.11 Info: Alarms Mask
Alarms Masked: TxAIS Terr REF TxClk BUC
Buf-Slip AGC RxAIS Sat EbNo LNB CEX
A sample Alarms Mask Info screen is shown here. Note that, while all available masks are
displayed here, this screen will show only the alarm(s) that are currently masked. For any alarm
that is not masked, a blank space assumes that item’s designated screen position.
5.2.4.12 Info: Misc
Miscellaneous: Normal
1:1 Switch=Not connected Online
The Miscellaneous Info screen provides the following information:
Display Item Configuration Setting
Top line Operational Mode Test Mode or Normal.
Bottom line
1:1 Switch Link Status Connected or Not Connected.
Redundancy Status Offline or Online.