Comtech EF Data CDM-625 - Manual (Page 642)

CDM-625 Advanced Satellite Modem Revision 15
Appendix F MN-CDM625
F–24
Selection Setting
Fault-Logic
This controls whether or not a HPA fault is indicated on the Fault status, and activates
the Summary Fault Relay. Select Summary or No-Summary.
LNA (LNA power enable) Select Off or On.
Fault-Logic
This controls whether or not a LNA fault is indicated on the Fault status, and l activates
the Summary Fault Relay. Select Summary or No-Summary.
Cal
To calibrate, select YES and press ENTER. Calibration allows the system to determine
nominal LNB or LNB power consumption, performed at initial installation only. (Default is
NO.)
Press ENTER when done.
F.3.3.3.3.3.1.4 ODU: FSK-control  KST  Information
KST Info: Model Tx+Rx-Param
Misc Numbers ()
These read-only screens provide the ODU’s current configuration information without risking
inadvertent changes.
Use the ◄ ► arrow keys to select Model, Tx+Rx-Param, Misc, or Numbers, and then press
ENTER.
Once any KST Info screen has been viewed, press ENTER or CLEAR to return to the previous
menu.
F.3.3.3.3.3.1.5 ODU: FSK-control  KST  Information  Model
MODEL: KST-2000B
HPA: CEFD-SSPA
This screen displays the KST and HPA model numbers.
F.3.3.3.3.3.1.6 ODU: FSK-control  KST  Information  Tx+Rx-Param
Info: Tx:Off 13955MHz 10dB
Rx: 11950MHz 20dB Ref:087
This screen displays the Tx and Rx states, Frequencies, and Attenuation, and the reference.