Comtech EF Data CDM-625 - Manual (Page 141)

CDM-625 Advanced Satellite Modem Revision 15
Front Panel Operation MN-CDM625
5–41
5.2.1.10 CONFIG: Misc
Misc: G.703-LineCode IDR-ESC HSSI RTS
Audio-Vol HiRateESC WarmUp Stats MEO ()
Use the ◄ ► arrow keys to select G.703-LineCode, IDR-ESC, HSSI, RTS, Audio-Vol, HiRateESC,
WarmUp, Stats, or MEO and then press ENTER.
5.2.1.10.1 CONFIG: Misc  G.703-LineCode (Ternary Code)
Parameters are editable only when the Data Interface Type is G.703.
Tx G.703/DDO Code= AMI (AMI,B8ZS)
Rx G.703/IDI Code= AMI (AMI,B8ZS) ()
The choices displayed here depend on the selected G.703 interface type. Use the ◄ ► arrow
keys to select either the G.703 Tx or Rx Ternary Code, and then use the ▲▼ arrow keys to select
the desired code. Press ENTER when done. The available choices are as follows:
Selection For:
HDB3 E1, E2 or sub-rate operation
B8ZS T1 and Unbalanced T2 operation
B6ZS Balanced T2 operation
AMI
5.2.1.10.2 CONFIG: Misc  IDR-ESC
Parameters are editable only when the Framing Mode is IDR.
IDR-ESC-Type Tx:64k Data (64kData,Audio)
Rx:64k Data ()
Use this menu to determine if the 64 kbps channel in the IDR Engineering Service Channel (ESC)
overhead, normally reserved for the two 32 kbps ADPCM audio channels, should instead carry
user data. The rear panel Overhead connector provides the appropriate EIA-422 interface for
this option.