TeeJet Legacy 6000 Manual - Manual (Page 90)

Legacy 6000
98-05053 R2
85
Point. Point map object. when pressed, a point is placed at the vehicle location.
hazard. hazard map object. when pressed, a hazard is placed at the vehicle location.
engages FieldPilot. For FieldPilot to engage, the gPS antenna must be within 1/3 of
the boom width from the established guideline.
displays to show that FieldPilot is engaged. if pressed, FieldPilot will disengage. if the
machine is equipped with the optional steering wheel sensor and the steering wheel is
turned while FieldPilot is engaged, FieldPilot will automatically disengage and manual
steering will be required.
Solid and Boom Patterns
applied areas can be viewed as solid painted areas or as hash marks that repre-
sent the spray boom. the solid pattern is used to assist in locating skipped areas
of application. the hash marks (boom pattern) is used to show overlaps. to switch
from one view to the other, press the View Options softkey. use the Arrow keys
to toggle between Solid and Boom patterns. Press the Enter button to accept the
selection.
Figure 4-9: Solid and Boom Patterns
SyStem, waRNiNg, aNd eRRoR meS-
SageS
Fieldware for the Legacy 6000 provides feedback in the form of system messages,
warnings, and error messages. this sample information is displayed in the banner
bar of the affected page. in addition, some messages are displayed on the lightbar
(refer to ChaPteR 4 - LightBaR iNdeX for additional information).
View Options
softkey
Arrow keys
Enter button