TeeJet Legacy 6000 Manual - Manual (Page 105)

Chapter 4 - operation 100
Figure 4-29: Right-hand Approaching/Vehicle Tracking Slightly Right of Guideline
(Swath Mode)
applied area detection
Fieldware detects when the vehicle has entered a previously-applied area and can
also be configured to notify the operator when approaching a previously marked
hazard. To use applied area detection, the “Lightbar Setup - Alarm” menu field
must be configured prior to starting guidance. Refer to CHAPTER 2 - LIGHTBAR
SetuP for additional information.
Previously applied area detection
as a vehicle enters a previously applied area, the lightbar will display the message
“aPPLied” and the red stoplights will illuminate. if the vehicle continues product
application while driving in the applied area, the console alarm will sound. if prod-
uct application is terminated while in the applied area, the alarm will not sound.
once the vehicle exits the previously-applied area, the red stoplights will turn off or
change to green once product application is resumed. the green illuminated stop-
light indicates that the vehicle is completely outside an applied area and product
application can commence.
Figure 4-30: Applied Area Detection