TeeJet Legacy 6000 Manual - Manual (Page 56)

Legacy 6000
98-05053 R2
51
aRm LauNCheR
Several applications are launched from the application Rate management (aRm)
page that are required prior to starting product application.
Figure 3-4: ARM Page
No PCmCia Card
if the PC Card setting in Console Setup is set to “No”, the aRm Launcher will be
displayed differently. Because no data is stored on a PC Card, there is no need
to name files or establish reports. The Job Report application and ARM Setup
softkeys will not be shown and some settings in aRm Setup will no longer be pres-
ent.
Calibrations
the following calibrations are possible in the Legacy 6000 system:
distance/Speed
•
Liquid Pressure
•
granular
•
Liquid Based Flowmeter
•
Nh3 Flowmeter
•
Seeder
•
all calibrations (except status monitors) result from a comparison of an actual
value and reported value. Calibration units are based on the units selected during
Channel Setup. Prior to calibration, the DCM must be configured using Channel
Setup.
Not included if PC Card is not used