TeeJet Legacy 6000 Manual - Manual (Page 63)

Chapter 3 - Product application Setup 58
Figure 3-12: Job Report Options
three additional softkeys are displayed on the right side of the screen. they allow
the operator to toggle between the available data screens without leaving the Job
Report Setup menus. the All Settings softkey displays all of the options available
(the main screen). the Weather Settings softkey displays all of the options pertain-
ing to weather conditions (wind speed, temperature, relative humidity). the Soil
Settings softkey displays all of the options pertaining to soil conditions (moisture,
condition, texture, tillage, and growth stage).
Table 3-3: Job Report Items
Item description
wind Speed wind speed (units of measurement are established during Console Setup). if no wind
speed is to be entered, set to “No”.
wind direction wind direction (Ne, e, Se, S, Sw, w, Nw, N, not observed).
temperature temperature (units of measurement are established during Console Setup). if no
temperature is to be entered, set to “No”.
Relative humidity Relative humidity (units of measurement are established during Console Setup). if no
relative humidity is to be entered, set to “No”.
Current weather weather condition (sunny, cloudy, partly cloudy, rain, snow, not observed).
Soil moisture Soil moisture (dry, moist, wet, not observed)
Soil Condition Soil condition (good, trashy, smooth, rough, plant debris, cloddy, not observed).
Soil texture Soil texture (fine, medium, course, not observed).
Soil tillage Soil tillage (no till, min till, conv till, not observed).
growth Stage growth state (pre-plant, pre-emergence, post-emergence, not observed).
All Settings
softkey (F8)
Weather Settings
softkey (F9)
Soil Settings
softkey (F10)