TeeJet Legacy 6000 Manual - Manual (Page 79)

Chapter 3 - Product application Setup 74
Level softkey
(F7)
Figure 3-29: Establishing Antenna Height
enter the height of the gPS antenna above the ground. the initial value in the L6k
system is 0.0 feet. after changing the antenna height, the user will be prompted
to restart the Legacy 6000. Press the Enter button to continue the setup process.
Restart the Legacy 6000 when finished by cycling the power.
Figure 3-30: Establishing Antenna Height
Tilt sensor Calibration
once the antenna height has been entered and the vehicle is situated on level
ground, the tilt sensor must be calibrated (leveled). to access the level feature:
1. Park the vehicle on a level surface.
2. Select the System Tools softkey from the Main Launcher page.
3. Select the Device Manager softkey. Select the “gPS Receiver” option.
4. Press the Level (F7) softkey to calibrate the tilt Sensor. the message
“drive to a level spot and stop completely. Press the Next button” will be
displayed. Press the Next button once the vehicle is stopped at the level
location. Choose a location where the vehicle can easily be turned.
Enter button
System Tools
softkey
Device Manager
softkey (F2)