TeeJet Legacy 6000 Manual - Manual (Page 82)

Legacy 6000
98-05053 R2
77
ChaPteR 4 - oPeRatioN
PRoduCt aPPLiCatioN
once application Setup is complete, product application can begin. Product appli-
cation is accomplished by pressing the ARM Bullseye softkey, located on the ARM
Launcher page. when the Bullseye is pressed, settings are loaded onto the dCm
along with implement setup information, control parameters, and data files. Once
the information is loaded, the Rates page will be displayed (refer to Figure 4-2).
Figure 4-1: ARM Launcher Page
NOTE: During OPERATION, more softkeys may be available on the right side of
the screen than can be displayed at one time. Additional softkeys can be
accessed by highlighting a softkey with the Right Arrow key and
scrolling up or down with the Up and Down Arrow keys.
Rates Pages
the Rates pages display the product name at the top of the page as well as the
current application rate, speed, material applied, acres applied, and remaining
amount of material and acres. to view the amount of remaining product, the initial
volume of material must be entered during Product Setup. For each product there
is also an alternate Rates page. to access the alternate Rates page, press the Ad-
ditional Information softkey. information displayed on the alternate page will vary
based on Channel Setup. the page typically displays distance traveled, active
swath width, target rate, and actual rate.
ARM Bullseye softkey
ARM Bullseye
softkey (F6)
Additional Infor-
mation softkey
(F6)
Arrow keys