TeeJet Legacy 6000 Manual - Manual (Page 157)

appendix B - Creating Calibration table 152
Since Cal# Basis is not completed during Channel Setup, a new screen
•
will be displayed during calibration. the screen will display the same
name entered for Cal# Basis during Channel Setup.
Proceed through the calibration process. Name the parameter and repeat
•
the process for each calibration table parameter.
NOTE: If GATE HEIGHT is to be used for the Cal# Basis name during Channel
Setup, it has already been established as a pre-named parameter in Cali-
bration 1 INCH - 12 INCH.