TeeJet Legacy 6000 Manual - Manual (Page 18)

Legacy 6000
98-05053 R2
13
Figure 2-3: Initial Installation - Change Notification
each dCm is capable of running two products (channels). each channel must be
turned on (yeS) and an id assigned if the channel is used.
3. highlight the desired channel in the center of the screen by using the Ar-
row keys and press the Enter button.
4. turn the channel on (yeS) if in use. Set a unique id number for each
channel (channel one is typically set to id 1).
Figure 2-4: Channel Assignment
the system will guide the operator through a series of commands to establish
the base channel and configure control of the other existing channels. One of the
channels must be established as the base channel to handle speed input.
Arrow keys
Enter button