TeeJet Legacy 6000 Manual - Manual (Page 85)

Chapter 4 - operation 80
test Speed
test Speed can be used to simulate speed without movement. test Speed is ac-
cessed by pressing the System Tools softkey. Scroll through the device manager
options using the Arrow keys and select the “Speedometer” option. Press the Test
Speed softkey. turn test Speed “oN” by using the Arrow keys and enter the speed
for simulation. apply the settings by pressing the Forward Arrow softkey. Press
the Back Arrow softkey to return to the rate page and start using test speed. if the
boom and pump are on, the system will begin product application. the rate page
will display the speed highlighted black to indicate test Speed is active.
NOTE: Once settings are applied, the system will start to operate at the entered
test speed.
Figure 4-5: Test Speed
Reset initial Quantity
Resetting the initial quantity is a feature used to monitor the amount of product
remaining for application. to reset the value, press the Reset Initial Quantity soft-
key and accept the default value by pressing F6, or use the Arrow keys to set the
appropriate value and then press F6 to apply the settings. initial Quantity is estab-
lished during Product Setup.
System Tools
softkey
Test Speed
softkey
Forward Arrow
softkey (F6)
Back Arrow
softkey (F1)
Arrow keys
Reset Initial
Quantity softkey