TeeJet Legacy 6000 Manual - Manual (Page 110)

Legacy 6000
98-05053 R2
105
ShaPe FiLeS
the 3.14 software release for the Legacy 6000 allows for the generation of shape
files. Shape files are useful tools as many of TeeJet’s customers use third party
giS software to plot, store, and analyze data collected by teeJet products. to re-
main compatible, 3.14 software now allows for the generation of shape files in the
standard formats of .ShP, .ShX, .dBF, and .PRJ.
To enable shape file generation, select the System Setup softkey followed by the
Console Setup softkey. use the Arrow keys to scroll down to “Shapefile” and press
the Enter button. the following selections are available:
No - no shape files will be generated at the end of the job, only RCD files
•
are stored.
Yes - shape files and RCD files are generated.
•
Prompt - the user determines if shape files are generated before exiting
•
the job.
Shape files are generated at the end of each job. If a job is being resumed, new
data is appended to the end of the old shape files.
Figure 4-36: Shape Files
System Setup
softkey (F1)
Console Setup
softkey
Arrow keys
Enter button