TeeJet Legacy 6000 Manual - Manual (Page 66)

Legacy 6000
98-05053 R2
61
entering File Names
File names can be entered to designate the use of existing Record, Boundary,
Guideline, and Map files (extensions .RCD, .BND, .GLN, or .GMF). To use an
existing record file, press the File softkey. the File softkey will launch a filename
dialog from which an existing record file can be selected. Once a file has been
selected, press the Forward Arrow softkey to return to the Record File page. Press
the Forward Arrow softkey again to save the selection and return to ARM Setup.
Once the desired settings have been configured, press the Forward Arrow softkey
on the Main ARM Setup page to save the settings and return to the ARM Launcher
page.
Figure 3-14: ARM Setup
Swath manager automatic Boom Section Control
Fieldware for the Legacy 6000 can automatically control the on/off state of boom
sections. Swath Manager can operate in five modes (Boom 50%, Boom 100%,
0%, 50%, and 100%).
Swath manager Lookahead
Fieldware for the Legacy 6000 has two time settings for the lookahead of the ve-
hicle to turn boom sections on and off.
Forward Arrow
softkey (F6)
File softkey (F7)