TeeJet Legacy 6000 Manual - Manual (Page 60)

Legacy 6000
98-05053 R2
55
Figure 3-8: System Setup for Priming
3. start prime. while in the Prime Page of arm Launcher, press the Prime
button on the front of the pump (top button) and the pump will start pump-
ing material through to the point of injection. the pump will stop automati-
cally once the pump volume reaches the preset prime value. to view the
live prime process, select the Prime State softkey. Repeat the process for
each pump.
Figure 3-9: Prime and Prime State Button
aRm Launcher page % Prime page
Prime State Reset Values to 0
Prime State
softkey (F6)
prime button