TeeJet Legacy 6000 Manual - Manual (Page 147)

Chapter 7 - eXt 142
RateS Page
the Rates page displays information related to the product and associated rate
controller (product name, current rate, speed, material applied, acres applied,
amount of material remaining). A completed field boundary must exist to calculate
the remaining acres. there are also two alternate pages available for view by se-
lecting the Next Page softkey.
Figure 7-10: Rates Page and Alternate Rates View Page
two pages are displayed during operation: the Rates page and the Map page.
each pay has the same general layout: a left column of softkeys, a center column
that displays rate or map information, and a right column of softkeys.
the left column is reserved for product control softkeys. there is a softkey for each
product used during the current product application. if there is only one product
being applied, no softkey will be displayed in the left column. (For example, if the
Legacy 6000 is connected to an external rate controller and is configured as a two-
product system, there will be two product control softkeys displayed.) if there are
more than four products during application, the left column will display a scroll bar
and additional softkeys will become available by scrolling down to the appropriate
icon. the left column reacts and is controlled the same for the Map page (refer
to Chapter 4). this allows for the control of product application while viewing the
application map. a product control softkey will contain the product name and the
current application rate.
the right column softkeys will vary depending on which page is currently being
viewed. when viewing the Map page, the right column contains all of the mapping,
guidance, and general viewing softkeys. when viewing the Rates page, the right
Next Page
softkey