TeeJet Legacy 6000 Manual - Manual (Page 139)

Chapter 7 - eXt 134
to view messages such as area applied and ground speed. if “off” is selected, a
lightbar is not required to collect data.
Table 7-1: Guidance Only Mode and Log Data Mode Settings
setup name setting description
Controller during Controller Setup, a controller driver name must be set to “None” to run
in guidance only mode.
guidance only
Lightbar text/Lights if the lightbar is set to “text/Lights”, machine guidance can be used. data is
logged to the PC Card (refer to Lightbar Setup for additional information).
Log data mode with a lightbar
Lightbar text only if the lightbar is set to “text only”, guidance cannot be used. where applied
data is logged to the PC Card.
Log data mode without a lightbar
Lightbar off if the lightbar is set to “off”, guidance cannot be used. where applied data is
logged to the PC Card. a lightbar is not required.
Rate CoNtRoL mode
Rate Control mode implies that an external rate controller is connected to one of
the Com ports on the Legacy 6000 console. during Rate Control mode, several
options exist where data can be collected with or without guidance. if rate data is
being collected without guidance, the use of a lightbar is optional. all data collected
during Rate Control mode is considered “as applied” data.
To configure Rate Control mode, the controller setting must be set to the type
of rate controller connected to the Legacy 6000 console. if this setting is set to
“None”, product application will not be possible.
Table 7-2: Rate Control Mode Settings
setup name setting description
Controller a driver Name during Controller Setup, a controller driver name must be selected to perform
product application.
Rate Control with guidance
Lightbar text/Lights if the lightbar is set to “text/Lights”, machine guidance can be used. data is
logged to the PC Card (refer to Lightbar Setup for additional information).
Log data mode with a lightbar and without guidance
Lightbar text only if the lightbar is set to “text only”, guidance cannot be used. as applied data
is logged to the PC Card.