Product setup – TeeJet Legacy 6000 Manual User Manual
Page 71
Chapter 3 - Product application Setup
66
PRoduCt SetuP
Product setup is used to name the product being applied by the Channel as well
as configure preset product application rates. To launch Product Setup, select the
Product Setup softkey on the ARM Launcher page.
the Product Setup page contains every setup option available in list format. From
this list each Product Setup item can be edited individually, or the Product Setup
wizard can be run. the top item on the setup list is the Setup wizard. to run the
Setup wizard, highlight
and press the Enter button. the Setup wizard will navigate through the entire
Product Setup item list.
NOTE: If Job Creation was based on an existing job and no changes are
needed to the Product name or rates, Product Setup can be skipped.
Figure 3-22: Product Setup
three additional softkeys are displayed on the right side of the screen. they al-
low the operator to toggle between the available data screens without leaving the
Product Setup menus. the All Settings softkey displays all of the options available
(the main screen). the View Products softkey displays all of the product informa-
tion in use. the View Rates softkey displays all of the rate information pertaining
to the product setup.
Product Setup
softkey
Arrow keys
Enter button
All Settings
softkey (F8)
View Products
softkey (F9)
View Rates
softkey (F10)