Rockwell Automation 7000A PowerFlex Medium Voltage Drive (A-Frame) - Classic Control - Manual (Page 234)

4-60 Commissioning
7000A-UM150F-EN-P – June 2013 7000 “A” Frame
Analog Outputs
Review the electrical schematics to understand which meters or
signals the user expects out of the analog output ports on the
Customer Interface Board.
To assign a parameter to an analog output,
ensure that you are at least in Advanced
access. From the main screen, press SETUP
(F8), and use the down arrow to highlight
Analog. Press Enter.
Use the down arrow to highlight the output
you wish to assign. When you press Enter,
you will be brought to the entire list of
parameters. Use the arrow and enter keys to
find the parameter you wish to assign, and
press Enter. This will take you back to the
Analog screen and you will see the new
parameter name beside your selected output.
Press EXIT [F10], go up to Parameters. Press
Enter, and then scroll down the list until you
reach Analog. Press Enter, and you will see
the same list of available ports and the
assigned parameter number, but not the name.