Rockwell Automation 7000A PowerFlex Medium Voltage Drive (A-Frame) - Classic Control - Manual (Page 127)

Operator Interface 3-33
7000 “A” Frame 7000A-UM150F-EN-P – June 2013
Figure 3.40 – Basic Access Level
Language Selection
The drive is capable of supporting multiple languages. The operator
interface supports these languages via language modules which must
initially be loaded via the flash card (refer to the section Flash
Memory Transfers).
To select an alternate language, press the [F9] key on the SETUP
screen. The screen will show all language modules currently loaded
as in Figure 3.41. Associated with each language is a module
revision level. Use the [cursor up] and [cursor down] keys to select
the desired language and press the [enter] key.
The operator interface will switch to the new language selected. It is
possible for other devices attached to the drive to request a language
change. If this occurs, the operator interface will switch to the new
language, if the required language module is loaded.
Figure 3.41 – Language Selection