Rockwell Automation 7000A PowerFlex Medium Voltage Drive (A-Frame) - Classic Control - Manual (Page 177)

Commissioning 4-3
7000 “A” Frame 7000A-UM150F-EN-P – June 2013
A T T E N T I O N A T T E N T I O N Servicing energized industrial control
equipment can be hazardous. Severe injury or
death can result from electrical shock, burn, or
unintended actuation of control equipment.
Hazardous voltages may exist in the cabinet
even with the circuit breaker in the off position.
Recommended practice is to disconnect or lock
out control equipment from power sources, and
confirm discharge of stored energy in
capacitors. If it is necessary to work in the
vicinity of energized equipment, the safety
related work practices of NFPA 70E, Electrical
Safety requirements for Employee Work
places, must be followed.
Notwithstanding the safety references here, all local codes and safety
practices are to be utilized when working on this product.
A T T E N T I O N A T T E N T I O N The CMOS devices used on the control circuit
boards can be destroyed or damaged by static
charges. If personnel will be working near
static sensitive devices, they must be
appropriately grounded.
Pre-Commissioning
In order to avoid complications during commissioning, it is important
Responsibilities
to ensure that the drive line-up is ready to be commissioned.
Included in this chapter is a six-point Pre-Commissioning Checklist.
It is necessary that the checklist be reviewed to ensure that all points
are completed in the order that they have been presented prior to
beginning the drive commissioning. Completing the items in the
checklist prior to commencing drive commissioning will help to
ensure that the start-up is performed in an organized and efficient
manner.