Rockwell Automation 7000A PowerFlex Medium Voltage Drive (A-Frame) - Classic Control - Manual (Page 116)

3-22 Operator Interface
7000A-UM150F-EN-P – June 2013 7000 “A” Frame
The next level is 'Basic'. This level and all levels above it allow
changes to be made to any parameter that can be viewed. The
number of parameters viewable increases from the previous level.
This level will be sufficient for configuring and maintaining the
drive for the majority of applications.
The last level intended for normal operation is the 'Advanced' level.
From this level, the drive can be configured in its entirety.
Two additional levels are used for trained service personal and are
only used when physical hardware changes are made to the drive.
Individual PIN numbers protects all levels, except the first. Use the
up/down cursor keys to select the desired access level. Then enter
the PIN value for the given access level and press [enter]. If the
correct PIN was entered, the access level will change.
Refer to Enter/Modify an Access Level for complete information
on the use of Access Levels.
Select a Parameter
Various operations require that a parameter be selected. All
selection operations are done via one of three methods described in
this section. All parameters are organized into groups. Selecting via
groups is the default method.
The screens associated with the selection process are called
automatically as part of the operation from other screens.
Via Groups
This is the default screen (Figure 3.23) used in the selection of a
parameter. It shows all the groups that are accessible for the operation
currently being performed. For example: if you are selecting a
parameter, any groups that are showing read-only parameters only will
not be shown. The current access level will also affect the number of
groups that are currently viewable, and can be selected from. If more
than one page of groups exist, press the [F8] and [F9] keys to view the
other pages.
Press the [cursor up] or [cursor down] keys to select the desired
group, (i.e. reverse video the group name). Press the [enter] key.
The SELECT screen (Figure 3.24) is displayed showing the members
of the selected group. The name of the selected group currently
being displayed is shown after the screen name, i.e. Motor Ratings.
Again using the [cursor up] or [cursor down] keys, and if required
the [F8] and [F9] keys to change the page, select the desired tag.
Press the [enter] key and the selected tag will be used to continue the
operation for which the selection process was being used.