8 what to do next – Rockwell Automation 57C570 AutoMax PC3000 User Manual User Manual
Page 97

6Ć5
1 2
3
1 2
3
E3
E3
E4
E4
123
123
20821ĆM
1
2 3
1 2
3
Set jumpers as shown when
you are installing the
Serial card in a PC chassis.
Set jumpers as shown when
you are installing the
Serial card in a PC chassis.
Set jumpers as shown when
you are installing the Serial
card in the AutoMax PC3000
Packaged Version.
Set jumpers as shown when
you are installing the Serial
card in the AutoMax PC3000
Packaged Version.
Figure 6.4 Ć Setting Jumpers E3 and E4
NOTE: Should you ever remove the microprocessor card from the
PC3000's chassis and continue to use the PC3000, you must
position the jumpers of E3 and E4 over pins 1 and 2 to enable the
load resistors.
If you want to run the AutoMax Programming Executive software on
the microprocessor, you must install the PC3000 driver and add the
Processor card to the PC's Device Manager list. Follow the
procedures in section 5.3 to do this.
6.8
What to Do Next
Finish installing your other system components. For information
about maintaining the PC3000, see chapter 20.