Rockwell Automation 57C570 AutoMax PC3000 User Manual User Manual
Page 113
8Ć1
8.0 INSTALLING AN AutoMax
FIBERĆOPTIC DCSĆNET
NETWORK
Installing a fiberĆoptic DCSĆNET network requires special
procedures and handling.
DANGER
THE USER IS RESPONSIBLE FOR CONFORMING WITH ALL APPLICABLE
LOCAL, NATIONAL, AND INTERNATIONAL CODES. WIRING PRACTICES,
GROUNDING, DISCONNECTS, AND OVERCURRENT PROTECTION ARE OF
PARTICULAR IMPORTANCE. FAILURE TO OBSERVE THIS PRECAUTION
COULD RESULT IN SEVERE BODILY INJURY OR LOSS OF LIFE.
WARNING
TURN OFF AND LOCKOUT OR TAG POWER TO BOTH THE RACK CONTAINING
THE NETWORK COMMUNICATIONS MODULE AND THE TRANSCEIVER
(RACKĆMOUNTED OR STANDĆALONE) BEFORE VIEWING THE FIBERĆOPTIC
CABLE OR TRANSMITTER UNDER MAGNIFICATION. VIEWING A POWERED
FIBERĆOPTIC TRANSMITTER OR CONNECTED CABLE UNDER MAGNIFICATION
MAY RESULT IN DAMAGE TO THE EYE. FOR ADDITIONAL INFORMATION,
REFER TO ANSI PUBLICATION Z136.1Ć1981. FAILURE TO OBSERVE THIS
PRECAUTION COULD RESULT IN BODILY INJURY.
For information about:
See this section:
Installing the StandĆAlone Transceiver
8.1
Installing the Rack/Power Supply and RackĆMounted
Transceiver
8.2
Installing the FiberĆOptic Cable
8.3
Attaching the FiberĆOptic Connectors
8.4
Connecting a FiberĆOptic Cable Between a StandĆAlone
Transceiver and a RackĆMounted Transceiver
8.5
What to Do Next
8.6