Rockwell Automation 57C570 AutoMax PC3000 User Manual User Manual
Page 2
E1997 Rockwell International Corporation.
AĆB, AllenĆBradley, AutoMax, Data Highway Plus, PanelView, PLC, PLCĆ5, RediPANEL, Reliance,
and ReSource are trademarks of Rockwell Automation.
Multibus and Intel are a trademarks of Intel Corporation.
Motorola is a registered trademark of Motorola Corp.
Phoenix and Combicon are registered trademarks of Phoenix Contact Ltd.
Excel, Plug and Play, and Windows 95 are registered trademarks of Microsoft Corp.
The information in this user manual is subject to change without notice.
DANGER
ONLY QUALIFIED ELECTRICAL PERSONNEL WHO ARE FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THIS EQUIPMENT AND THE HAZARDS
INVOLVED SHOULD INSTALL, ADJUST, OPERATE, AND/OR SERVICE THIS
EQUIPMENT. READ AND UNDERSTAND THIS MANUAL AND OTHER
APPLICABLE MANUALS IN THEIR ENTIRETY BEFORE PROCEEDING. FAILURE
TO OBSERVE THIS PRECAUTION COULD RESULT IN SEVERE BODILY INJURY
OR LOSS OF LIFE.
DANGER
THE USER IS RESPONSIBLE FOR CONFORMING WITH ALL APPLICABLE
LOCAL, NATIONAL, AND INTERNATIONAL CODES. WIRING PRACTICES,
GROUNDING, DISCONNECTS, AND OVERĆCURRENT PROTECTION ARE OF
PARTICULAR IMPORTANCE. FAILURE TO OBSERVE THIS PRECAUTION
COULD RESULT IN SEVERE BODILY INJURY OR LOSS OF LIFE.
WARNING
THE USER MUST PROVIDE AN EXTERNAL, HARDWIRED EMERGENCY STOP
CIRCUIT OUTSIDE THE CONTROLLER CIRCUITRY. THIS CIRCUIT MUST
DISABLE THE SYSTEM IN CASE OF IMPROPER OPERATION. UNCONTROLLED
MACHINE OPERATION MAY RESULT IF THIS PROCEDURE IS NOT FOLLOWED.
FAILURE TO OBSERVE THIS PRECAUTION COULD RESULT IN BODILY INJURY.
WARNING
INSERTING OR REMOVING A MODULE MAY RESULT IN UNEXPECTED MACHINE
MOTION. POWER TO THE MACHINE SHOULD BE TURNED OFF BEFORE
INSERTING OR REMOVING THE MODULE. FAILURE TO OBSERVE THESE
PRECAUTIONS COULD RESULT IN BODILY INJURY.
CAUTION: This module contains staticĆsensitive components. Careless handling can
cause severe damage. Do not touch the connectors or the back of the module. When
not in use, the module should be stored in an antiĆstatic bag. The plastic cover should
not be removed. Failure to observe these precautions could result in damage to or
destruction of the equipment.