Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 155)

13Ć5
You must assign names to these registers so you can reference
them in the control programs. To assign variable names to the
remote rack status and control registers, use the scanner's Variable
Configurator Form. When you choose the Scanner Setup and Status
view, you see a form similar to the one shown in Figure 13.4.
Figure 13.4 Ć Scanner Setup and Status View
All the scanner setup registers are read and write accessible. The
RIO Status and Module ID registers are read only. You set the scan
mode and data rate and enable scanning during the execution of
the scanner initialization program, which you must create. For more
information, see chapter 16, Initializing the AutoMax PC3000 AĆB
Remote I/O Scanner."