Rockwell Automation 2094-EN02D-M01-Sx Kinetix 6200 and Kinetix 6500 Modular Multi-axis Servo Drives User Manual - Manual (Page 100)

100 Rockwell Automation Publication 2094-UM002E-EN-P - May 2012
Chapter 5 Connecting the Kinetix 6200 and Kinetix 6500 Drive System
Grounding the Modular Drive
System All equipment and components of a machine or process system should have a
common earth ground point connected to chassis. A grounded system provides a
ground path for short circuit protection. Grounding your modules and panels
minimize shock hazard to personnel and damage to equipment caused by short
circuits, transient overvoltages, and accidental connection of energized
conductors to the equipment chassis.
Ground the Power Rail to the System Subpanel
The 2094-PR
x and 2094-PRSx power rail ships with a braided ground strap, 100
mm (3.9 in.), that connects to the bonded cabinet ground bus. Connect the other
end to either the power rail ground stud or mounting bracket ground stud, if
mounting brackets are used.
Figure 52 - Connecting the Braided Ground Strap Examples
For power rail dimensions, refer to the Kinetix 6000 Power Rail Installation
Instructions, publication
2094-IN003 .
ATTENTION: The National Electrical Code contains grounding requirements,
conventions, and definitions. Follow all applicable local codes and regulations
to safely ground your system.
For CE grounding requirements, refer to Agency Compliance on
page 25 .
LIM PRS
PR
LIM
PR/PRS
LIM PRS PR
LIM PRS PR PR
PR
Ground Grid or Power
Distribution Ground
Bonded Cabinet
Ground Bus
Braided
Ground Strap
2094 Power Rail
(2094-PRSx shown)
Bonded Cabinet
Ground Bus
Bonded Cabinet
Ground Bus
2094 Power Rail
on 2094 Mounting Brackets
(2094-PRSx shown)
Line Interface Module
on 2094 Mounting Brackets
(2094-ALxxS shown)
Ground Grid or Power
Distribution Ground
Ground Grid or Power
Distribution Ground
Braided
Ground Strap
Braided
Ground Strap
Ground Stud
Ground Stud
Ground Stud
2094 Mounting Bracket
(2094-XNBRKT-1)
2094 Mounting Bracket
(2094-XNBRKT-1)