Konica Minolta bizhub PRESS C8000e - Manual (Page 365)

bizhub PRESS C8000 10-57
10.9 [03 Administrator Setting] - [01 System Setting] 10
7
Press [Start] on the screen. The machine starts the adjustment automatically.
% If any failure is found, an error code will be displayed to indicate the cause for each. Consult the
following table to fix the errors.
8
Repeat the steps from 4 to 7 until the message [Completed] is displayed.
9
Press [Return] to restore the Quality Adjustment Menu Screen.
Error code Error Remedy
Error 1 Register marks cannot be detected. Reset the chart in the correct position.
Error 2 Chart is positioned upside down. Reset the chart in the correct position.
Error 3 Pattern of chart cannot be detected. Use the correct chart.
Error 4 Adjustment is unavailable. Contact your service representative.
Error 5 Out of standard range Make the readjustment.
Error 6 Nonvolatile data error Check the installation of memory board.
Error 7 Accessed undesignated memory. Contact your service representative.
Error 8 Error related to memory Contact your service representative.
Error 9 Program error Contact your service representative.
Error 10 Chart is skew. Use the correct chart.
Error 11 Failed in scanning the image header in-
formation. Contact your service representative.
Error 12 RGB data error Check that the chart is correct, and con-
tact your service representative if any so-
lution can be found.
Error 13 Parameter setting error Contact your service representative.
Error 31 Abnormal sensor data Make the readjustment.
Error 51 Regression calculation error Make the readjustment.
Error 52 Array number overflow Contact your service representative.
Error 53 Regression order error Contact your service representative.
Error 54 Selected screen information error Contact your service representative.
Error 55 Color information error Contact your service representative.
[3]
[2]
[4]
[1]