3 interrupting job in progress: interrupt mode, Interrupting job in progress: interrupt mode -5 – Konica Minolta bizhub PRESS C8000e User Manual
Page 286
bizhub PRESS C8000
8-5
8.3
Interrupting Job in Progress: Interrupt Mode
8
8.3
Interrupting Job in Progress: Interrupt Mode
Use the Interrupt mode to interrupt copying in progress to perform a simple job.
Pressing Interrupt on the control panel stops the machine operation temporarily at the timing available for
interrupt copying and allows you to copy with different settings.
When interrupt copying is completed, the settings for the previous job will be restored automatically.
The Interrupt mode cannot be selected with the following conditions:
-
Machine is not operating printing or scanning job.
-
The Call for Service message displays or a paper misfeed occurs.
-
Machine is operating in Interrupt mode.
-
Machine mounted with Image Controller IC-601 is operating Prior Print, or a Prior Print job is on the
list of reserved jobs.
0
Reserve job cannot be operated in Interrupt mode.
0
Auto Low Power or Auto Shut OFF will not function during Interrupt mode.
1
Press Interrupt on the control panel.
The Interrupt LED flashes until the machine is ready for Inter-
rupt mode. When the machine is ready for Interrupt mode, the
message [Ready to print] is displayed in the message area and
the Interrupt LED turns steady.
The Copy Screen for Interrupt copying will be displayed.
2
Set copy conditions, as desired.
All copy conditions except Reserve mode can be specified.
3
Position the original, then press Start on the control panel to start the interrupt copying.
4
When Interrupt copying is completed, press Interrupt again.
The Interrupt LED will be turned out and the Machine Screen will be displayed, with the settings of the
initial job restored.
5
Press Start on the control panel to resume copying.