Konica Minolta bizhub PRESS C8000e User Manual
Page 202
bizhub PRESS C8000
6-38
6.7
Using Perfect Binder PB-503
6
% Selection of [ON] for [Cover Print] becomes available when a cover tray is selected from [Tray 1] to
[Tray 9].
% With [ON] for [Cover Print] selected, you may also specify the [Cover Print Side], selecting [Simplex]
for printing only on the front side, or [Duplex] to have both front and back sides printed.
% The cover printing result varies depending on whether the original page count is odd or even. For
details of finished result with each setting specified, see page 6-30.
16
Make the cover trimming setting.
Select [ON] or [OFF] from the right side of [Cover Trim].
% If the trimming width estimated by the machine does not fall within the range from 5 mm to 40 mm,
a message will be displayed to inform you that the trimming mode is unavailable. In this case, adjust
the cover or spine width to enable this setting.
% If the estimated amount exceeds 10 mm, the machine will automatically trim the cover whether this
function is activated or not.
17
Select the bind direction.
Select [Left Bind] or [Right Bind] on the right side of [Bind Direction].
18
Specify the spine width.
Press [Change Set] on the right side of [Spine Width (1-30 mm)] to display the Spine Width Screen.
Use the touch panel keypad, [
,], [+], or the control panel keypad to enter the desired value.
% This setting is effective with Cover Print set to [ON].
Press [OK].
19
Make fine adjustments in the lead edge, trimming width, and image position of the cover.
Press [Change Set] on the right side of [Fine Adjustment] to display the Fine Adjustment Screen.