Konica Minolta bizhub PRESS C8000e - Manual (Page 224)

bizhub PRESS C8000 6-60
6.9 Using Finisher FS-612 6
1
Place paper in the lower tray of the post inserter.
% Corner Staple/2 Position Staple: Place paper face up.
% Punch: Place paper face up.
% Fold & Staple: Place the face to be front side of the finished
set up.
% Tri-Fold: Place the face to be outside of the fold up.
% Align the guide plate with the paper.
NOTICE
Do not punch special paper type such as labels or tracing pa-
per. If you use special paper, unexpected trouble may be
caused to the punch kit.
2
Select the desired mode using the staple mode selection button and punch button.
% To select Corner Staple/2 Position Staple, Fold & Staple, or Tri-Fold, press the staple mode selec-
tion button to turn on the lamp of desired mode. To select Punch, press the punch button to turn
on the lamp.
% Punch and Corner Staple/2 Position Staple are compatible. To use it in combination, press the sta-
ple mode selection button to turn on the lamp. If any other function is not desired, turn off all the
lamps except that of Punch.
3
Press Start.
% To interrupt the output operation, press the Start button on the control panel of post inserter.
[1]: Staple mode selection button
[2]: Punch button
[3]: Start/Stop button